Best sellers

FORMS

Wet rotor circulators for hot domestic water systems.

The opening takes place with the power supply controlled by the thermostat - Absorption 3.45 VA (230 V) 3 VA (24 V) - Protection IP 40 (vertical position IP 44) - Cable length: 1 m - Starting current: 0 , 35 A (24 V model) - 0.25 A (230 V model) - Opening / closing time: 5-6 min.

For very quick ignition or when it is necessary to reach a higher temperature, we have ceramic resistances for biomass and pellet stoves.

Characteristics:

- Element temperature 1000°C in continuous or interchangeable operation.

- Resistant to oxidation and corrosion.

- Simplified method of heat exchange by passing air both externally and internally.

To replace the parts, you can count on the help of a certified technician from the company CLÁUDIO MARQUES. (call: 238692209)

Right automatic drain for radiator.

To replace the parts, you can have the help of a certified technician from Cláudio Marques.

Right automatic drain for radiator.

To replace the parts, you can have the help of a certified technician from Cláudio Marques.

2x11/4 reduction nut for circulator pump.

The hydraulic group is a low-temperature system controlled by a fixed-point thermostatic controller that determines a constant flow temperature for the underfloor heating circuit. It incorporates a contact thermostat system to be placed in the outflow pipe, which must precede the electrical supply of the circulating pump, and it stops it if the temperature exceeds the determined value. The valve has an integrated low temperature hydraulic circuit, most of the return circuit is routed to send to the circuit. The mixing group allows maintenance of the circulator without the need to empty the circuit.

Complete with:

Protection locks with built-in flowmeters (0-4 l / min)

Manual regulation valves prepared for electrothermal heads

No. 2 1" blind plugs with O-ring gasket

No. 2 1/2" water drain valves

Nr. 2 1/2" air vent valves with vent (side + manual)

No. 2 double metal supports

Note: to be completed with nr. 2 Progress 1" ball valve with red and blue butterfly handle, with pipe union, with or without thermometer (not included).

The CM monobloc heat pump is an ecological equipment with a high level of efficiency for the production of domestic hot water (A.Q.S.). The machine was produced with 316 stainless steel alloy, is equipped with a resistance of 1500W.

Stainless steel filling float for open expansion vessel faucet.

Stainless steel filling tap for open expansion vessel without float.